KLP 系列  1U 可程式定電壓、定電流、定功率直流電源供應器
共同規格:

TO->
PAGE 1

HOME

SPECIFICATIONS RATING/DESCRIPTION CONDITION
Stabilizer Type CV/CC Voltage/Current
Adjustment Range voltage 0-100% of rated voltage No minimum load required
current min-100% of rated current(note.1)
Source Effect voltage 0.01% Emax Over full source range
current 0.01% lmax
Load Effect voltage 0.01% Emax Over full load current range
current
(note.2)
0.01% lmax
(note.3)
Temperature Effect voltage 0.02%/°C 0-50°C
current 0.05%/°C
Time Effect (drift) voltage 0.05%/24hr After 30 minute warmup
current 0.05%/24hr
Error Sensing 0.25 volts per wire Above rated output
Isolation Voltage 600V d-c or peak Either output terminal to ground
Transient
Recovery for
Load Change
excursion 1% of Emax 50% load step 2A/μsec max
recovery 2 msec Return to 0.1% of setting
Turn on / turn off
Overshoot
Same as load transient response limits
Overvoltage
Protection
voltage 20-120% of Emax User selectable recovery
Overcurrent Protection current 72-120% of Imax User selectable recovery
Overtemperature Protection Shutdown User selectable recovery
Output Lead Fault Protection Shutdown User selectable recovery
Parallel Operation Active load sharing within 5% of I0 rated Up to 5 units maximum (note.4)
AC Input voltage nominal 100-240V a-c
Single phase
Wide range
range 100-255V a-c
DC Input voltage range 125-420V d-c No regulatory agency approval
Input Frequency nominal type 50-60 Hz Single phase
maximum 45-440 Hz Increased leakage above 66 Hz
Power Factor tpical 0.99 Meets EN 61000-3-2 typical
Maximum Input Current 120V a-c 13A rms Rated load (1200W)
240V a-c 6.5A rms
Inrush Current 265V a-c 40A Peak
132V a-c 20A
Input Fusing Circuit Breaker 2-line
Low a-c Protection Self Protected No fixed limits
Output Hold Up typical 10 milliseconds Ride through
Leakage
Current
115V a-c, 60 Hz 1.2mA max.  
230V a-c, 50 Hz 2.3mA max.
Dimensions 44.45 x 482.6 x 443.7 mm H x W x D
Weight 6.82kg  
note.1 : See Model Table for minimum programmable current.
note.2 : After settling effect.
note.3 : For 600V model: 0.02% + 3.3μA/V of compliance voltage.
note.4 : E-Series models are not Master/Slave capable.
  

上一頁

下一頁

以上規格及選購配備僅供參考,實際規格以KEPCO網站資料為準,或洽本公司業務人員

Copyright 2013 CHYNG HONG ELECTRONIC CO., LTD.  |  Contact us