BOP 系列  可程式 4 象限電源供應器
共同規格:

TO->
PAGE 1

HOME

SPECIFICATIONS RATING/DESCRIPTION CONDITION
Type of Stabilizer Voltage/Current 4-quadrant Switch mode
Switching Frequency 100KHz ±5% Output stage
Source Adjustment
Range
voltage -100% to +100% of rating Output stage
current -100% to +100% of rating 0-50°C
Sink Adjustment
Range
voltage -100% to +100% of rating 0-50°C, recuperated energy is sent back into line for general reuse
current -100% to +100% of rating
Voltage Stabilization
in Voltage Mode
source effect 0.05% of rating min-max input voltage
load effect 0.1% of rating 0-100% load current
time effect (drift) 0.02% of rating 0.5 - 8 hours
temperature effect 0.02%/°C of rating 0-50°C
ripple 2% Eo max p-p Includes switching noise
noise 0.2% Eo max rms
Current Stabilization
in Current Mode
source effect 0.05% of rating min-max input voltage
load effect 0.2% of rating 0-100% load current
time effect (drift) 0.02% of rating 0.5 - 8 hours
temperature effect 0.02%/°C of rating 0-50°C
ripple 2% Io max p-p Includes switching noise
noise 0.2% Io max rms
Error Sensing 0.25 volts per wire Above rated output
Transient Recovery in
Voltage Mode
maximum excursion 5% of nominal output nominal voltage, 50% load step
recovery time 200 μsec Return within 0.1% of set voltage
Output Common Mode Voltage 300V Output to chassis ground
Series Operation Master/slave Maximum of 3 identical units, up to 300V max.
Parallel Operation Master/slave Maximum of 5 identical units
Output Protection Limiting Voltage and current limited in four quadrants  
Output Stage Protection Output overvoltage / overcurrent, heat sink over temperature,
switchers overcurrent
Triggers latched shutdown protection of the output module and PFC stage.
Recover by cycling power off, then on or by pressing RESET at the front panel
Input Stage Protection (PFC) Internal overvoltage, undervoltage, overcurrent,
heat sink overtemperature, fan inoperative
Input circuit breaker overcurrent
Small Signal Bandwidth voltage channel 2 KHz maximum Into nominal resistive load
current channel 800 Hz maximum
(600 Hz Maximum) (note.1)
Into short circuit
Analog Control voltage or current
main channel
-10V to +10V Full range output
voltage and current
protection limit channel
+0.05V to +10V 0.5% to 100% of nominal range
Digital
Control
local Panel-mounted keypad  
remote IEEE 488-2 (GPIB) SCPI
remote RS 232
remote RS 485 (BITBUS) Used for series and parallel configurations
Display front panel 4" backlit LCD displays all functions  
remote All parameters read back on RS 232 and GPIB buses  
Rise/Fall Time voltage channel 250/200 μsec Into nominal resistive load
current channel 0.7/1.2 mSec Into short circuit
Input voltage nominal 230Vac 50/60 Hz
Single phase
range 176-264Vac 47-63 Hz
Input current nominal type 176Vac - 9.5A(7.5A); (note.2)
264Vac - 6.4A(4.4A); (note.2)
Maximum
Temperature operating 0 to +50°C Full rated load
storage -20 to +85°C  
Cooling Two internal fans Exhaust to the rear
Humidity 0 to 95% RH Non-condensing
Shock 20g, 11msec ±50% half sine Non-operating
Vibration 5 -10 Hz 10mm double amplitude 3-axes, non-operating
  10-55 Hz 2g 3-axes, non-operating
Altitude Sea level to 10,000 ft.  
Dimensions   133.3 x 482.6 x 546.1 mm H x W x D
Weight 24.1kg  
note.1 : BOP 6-125MG only.
note.2 : BOP 6-125MG and BOP 10-75MG only.
  

上一頁

下一頁

以上規格及選購配備僅供參考,實際規格以KEPCO網站資料為準,或洽本公司業務人員

Copyright 2016 CHYNG HONG ELECTRONIC CO., LTD.  |  Contact us