BOP 系列  可程式 4 象限電源供應器
MG 系列規格 :  

TO->

PAGE 2

HOME

Output Model CLOSED LOOP GAIN

OUTPUT IMPEDANCE

CV CC VOLTAGE
CHANNEL
GV (V/V)
CURRENT
CHANNEL
GI (A/V)
VOLTAGE MODE CURRENT MODE
V A SERIES R
(mΩ)
SERIES L
(μH)
SHUNT R
(Ω)
SHUNT C
(μF)
0 - ±6
0 - ±125
BOP 6-125MG 0.6 12.5 0.05 1.5 24 1150
0 - ±10
0 - ±75
BOP 10-75MG 1.0 7.5 0.13 2.0 67 976
0 - ±20
0 - ±50
BOP 20-50MG 2.0 5.0 0.40 8.3 200 371
0 - ±25
0 - ±40
BOP 25-40MG 2.5 4.0 0.63 15.8 313 165
0 - ±36
0 - ±28
BOP 36-28MG 3.6 2.8 1.30 25 640 103
0 - ±50
0 - ±20
BOP 50-20MG 5.0 2.0 2.50 50 1250 55
0 - ±72
0 - ±14
BOP 72-14MG 7.2 1.4 5.14 104 2570 33
0 - ±100
0 - ±10
BOP 100-10MG 10.0 1.0 10.0 163 5000 16
NOTE: When connecting active loads, the steady-state voltage of the active load must not exceed the maximum voltage rating of the BOP. Otherwise the overvoltage protection will shut down the power supply.
 
GL 系列規格 :
Output Model CLOSED LOOP GAIN

RIPPLE AND NOISE

CV CC VOLTAGE
CHANNEL
GV (V/V)
CURRENT
CHANNEL
GI (A/V)
VOLTAGE MODE CURRENT MODE
V A
0 - ±10
0 - ±100
BOP 10-100GL 1.0 10.0 0.02% 0.01%
0 - ±20
0 - ±50
BOP 20-50GL 2.0 5.0 0.02% 0.01%
0 - ±50
0 - ±20
BOP 50-20GL 5.0 2.0 0.02% 0.01%
NOTE: When connecting active loads, the steady-state voltage of the active load must not exceed the maximum voltage rating of the BOP. Otherwise the overvoltage protection will shut down the power supply.
    For other Volt-Ampere combinations, please consult factory.
 
選購配備 訂購訊息:
編號 品名
Line Cord Set 118-1087 250V/20A, provides connection to a-c mains via Nema 6-20P connector
Line Cord Set 118-1088 250V/20A, provides connection to a-c mains via Nema L6-20P locking type connector
142-0527 Mating Connector, Trigger Port
142-0485 Mating Connector, IEEE 1118 (BITBUS) Port
SNC 488-1 IEEE 488 (GPIB) Cable (1 meter)
SNC 488-2 IEEE 488 (GPIB) Cable (2 meters)
SNC 488-4 IEEE 488 (GPIB) Cable (4 meters)
142-0449 Mating Connector, Analog Input Port: (D-Subminiature Connector, 15 Pins, Male
108-0374 Hood for 15-pin D-Subminiature Connector
CS 04 Chassis Slides
KIT 219-0449 2 units in parallel, increase current
KIT 219-0446 3 units in parallel, increase current
KIT 219-0447 4 units in parallel, increase current
KIT 219-0448 5 units in parallel, increase current
KIT 219-0443 2 units in series, increase voltage
KIT 219-0444 3 units in series, increase voltage
KIT 219-0480 2 x 2: 2 parallel branches of 2 series-connected units
KIT 219-0481 3 x 2: 2 parallel branches of 3 series-connected units
RS 232 KIT 219-0436 Contains RJ11 to RJ45 Patch cord, RJ 45 Patch cord, two RS 232 adapters (one w/male pins for DTE equipment, one w/female pins for PC) and two RS 232 Loop Back test Connectors (one 6-pin and one 8-pin)
 

上一頁

下一頁

以上規格及選購配備僅供參考,實際規格以KEPCO網站資料為準,或洽本公司業務人員

Copyright 2016 CHYNG HONG ELECTRONIC CO., LTD.  |  Contact us